Mellanox drivers - Top 4 Download

Mellanox drivers download in Router / Switch / Ap

Mellanox MQM8790 Switch Firmware 27.2008.2102

Changes and New Features:- 100Gb/s speed BER improvements. - Added support for the following Active Fiber HDR cables: MFS1S00-H130E and MFS1S00-H150E. For further information see section Validated and Supported HDR Cables.  - Added support for "Maximum PLR Counts per second (cps)" counter.  - Updated the PPNCT group/DiagnosticData to use SymbolBER ...

Mellanox MQM8790 Switch Firmware 27.2008.2402

Bug Fixes:- Modules failed over 400KHz. The default I2C frequency has now been set to 100KHz for all modules. - The IsPLRMaxRetransmissionRateSupported and IsEffectiveCounterSupported counters were incorrectly added to the Virtual Port in the IB switch.  - Packet bandwidth does not spread according to the VL Arbitration configuration in split ports. ...

Mellanox MQM8790 Switch Firmware 27.2008.3328

Changes and New Features:- Added GA-level support for AOC splitter cables MFS1S50-H0xxE-LL. Note that the cables above are HDR-only and are supported up to 30 meters. - Added GA-level support, on supported cables, for direct firmware burning from the internal flash storage to reduce the bandwidth and accelerate the burning ...

Mellanox MSB7790-E rev. Ax Switch Firmware 11.1910.0618

Changes and New Features:- Added support for PortStateTable standard SMP MAD - Added support for PSU utilization and consumption of output power - Added support for PSU temperature and 12V Vout monitoringAbout Switch Firmware:Given the large variety of models and different methods for upgrading the switch, if you wish to apply ...

Mellanox MSB7890 rev. Ax Switch Firmware 15.2008.3000

Changes:- Stability improvementsAbout Switch Firmware:Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user. Usually ...

Mellanox MSX6025F rev.Ax Switch Firmware 9.4.1000

Changes: - Added system MKey support Bug Fixes: - UID LED MAD is not responsive. - PSU fans set to work with 60% max speed by default - The command “show interfaces ib transceiver” shows no cable is connected while link is up. Known Issues: - ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.1910.0618

Changes and New Features:- This is the initial GA firmware version for Mellanox Quantum 40-port Non-blocking Externally Managed HDR 200Gb/s InfiniBand Smart Switch (MQM8790). - Enables the user to split a single physical quad-lane QSFP port into 2 dual-lane ports using the break-out cable.About Switch Firmware:Given the large variety of models ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2000.1400

Changes and New Features:- HDR speed rate is at GA level. - Added support for Break-Out Cable auto-sensing. - When working with 8 VLs, TP does not function due to buffers’ configuration.About Switch Firmware:Given the large variety of models and different methods for upgrading the switch, if you wish to apply ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2000.1600

Changes and New Features:- Wrong behavior of ARGroupTableCopy MAD. - On rare occasions, HDR link may not raise properly when using optical cables. - Link flapping and packet loss during High/Low temperature changes.  - When using a copper splitter cable up to 2m length in HDR100 mode, traffic may drop. About Switch ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2000.1886

Changes and New Features:- A port may hang while Link-Maintenance runs on it and the second port’s link is toggled. - HDR link up time when using optical cables may take 6 minutes or more (up to 20 minutes).About Switch Firmware:Given the large variety of models and different methods for upgrading ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2000.2046

Changes and New Features:- [Beta] Mellanox Scalable Hierarchical Aggregation and Reduction Protocol (SHARP) technology improves the performance of MPI operations by offloading collective operations from the CPU to the switch network, and by eliminating the need to send data multiple times between endpoints. - Added QDR/FDR support in Quantum switch systems ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2000.2182

Changes and New Features: - Fixed an issue that caused the packets to be transmitted from a wrong output port due to a wrong configuration of the packet classification decision in the switch forwarding database cache key, that caused both AR eligible packets and AR ineligible packets to hit the same ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2000.2306

Bug Fixes:- Fixed an issue that resulted in high BER when using optical module with module firmware older than 37.50.316. About Switch Firmware:Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2000.2626

Changes and New Features:- SDR link speed on InfiniBand systems is now available for all cables, including cables that do not advertise InfiniBand speed in their memory map. - SHARP (LLT) is at GA level, whereas SHARP (SAT) is at Beta level. - Added support for Error Injection with PTER register.About ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2000.3276

Changes and New Features:- Degradation in throughput might be experienced when using HDR100 cables with a length of 30m and above. Bug Fixes:- Degradation in throughput might be experienced when using HDR100 cables with a length of 30m and above.About Switch Firmware:Given the large variety of models and different methods for ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2007.0300

Changes and New Features:- Added support for link-negotiated credit size. - Added support for DCQCN Congestion Control. Bug Fixes:- As the switch does not send auto-negotiation indication, after resetting/power cycling a ConnectX-6 HCA, some HCAs get stuck in "polling" state. - After performing a software reset on the switch while using ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2007.0618

Bug Fixes:- Running 2 flows in parallel is currently not functional in SHARP (SAT).- Reading the Serial Number by the MSPS register is not functional on the new Delta PSU model. - When using Mellanox AOC cables longer than 50m use one VL to achieve full wire speed.About Switch Firmware:Given the ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2008.0232

Changes and New Features:- Added support for FDR link speed when connecting a ConnectX-3 HCA with an HDR Mellanox Quantum switch. - SHARP stability improvements. - Added support for legacy SHARP port and performance counters. - Enabled KP4RS FEC on Active Fiber cables (OPN: MFS1S00-V0xxE).  - Disabled PLR on Active Fiber ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2008.1300

Changes and New Features:- EDR link speed is now supported when using ConnectX-6 100Gb/s HCA and connecting with HDR optical cables. About Switch Firmware:Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2008.1604

Changes and New Features:- Added support for MAD security policy for SHARP. - Enabled PLR with Low-Latency (LL)-FEC mode in optical cables up to 30m.  About Switch Firmware:Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2008.2102

Changes and New Features:- 100Gb/s speed BER improvements. - Added support for the following Active Fiber HDR cables: MFS1S00-H130E and MFS1S00-H150E. For further information see section Validated and Supported HDR Cables.  - Added support for "Maximum PLR Counts per second (cps)" counter.  - Updated the PPNCT group/DiagnosticData to use SymbolBER ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2008.2500

Changes and New Features:- Added support for cable MMS1W50-HM NVIDIA transceiver, IB HDR, up to 200Gb/s, QSFP56, MPO, 1310nm, FR4 on MQM8700-HS2R and MQM8790-HS2R systems. - Added GA-level support for Active Optical Cables MFS1S00-H0xx-LL. Note that the cables above are HDR-only and are supported up to 30 meters. - New SHARP jobs ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2008.3328

Changes and New Features:- Added GA-level support for AOC splitter cables MFS1S50-H0xxE-LL. Note that the cables above are HDR-only and are supported up to 30 meters. - Added GA-level support, on supported cables, for direct firmware burning from the internal flash storage to reduce the bandwidth and accelerate the burning ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2010.1202

Changes and New Features:- Added support for PortVLXmitFlowCtlUpdateErrors counters.About Switch Firmware:Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a ...

NVIDIA Mellanox MQM8790 Switch Firmware 27.2010.1310

Changes and New Features:- Added ES-level support for congestion control class key. - Added ES-level support for vendor class key.About Switch Firmware:Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps ...