Ligowave drivers - Top 4 Download

Ligowave drivers download in Router / Switch / Ap

Ligowave NFT 1Ni Access Point Firmware 7.3-2

What’s new in 7.3 firmware release- Implemented Infinity branding - Added Reset Tool support - Added Device discovery - Added a control on AP to define max allowed stations - Added a control on AP to define minimal signal level for station - Added station kick-out option - Added SISO/MIMO radio ...

Ligowave NFT 1Ni Access Point Firmware 7.52

What’s new in 7.52 firmware release- Added UAM/CoovaChilli support (Throughput up to 60Mb/s) - Added repeater mode with third party AP support - Added router mode - Added an option to close wireless session from RADIUS (RADIUS initiated disconnect) on WPA/WPA2-Enterprise - Added option for indoor-outdoor channels-frequency filtering in list - ...

Ligowave LigoDLB Router Firmware 7.51

What’s new in 7.51 firmware release- LigoDLB (7.51) iPoll 2 is compatible with Deliberant APC (7.00) iPoll 2 NEW:- Added Management over wireless on Station/CPE - Added VAP support - Added Spanish language into GUI - Added ATPC control into GUI - Added Spectrum Analyzer - Added HTTP disable/enable option - ...

Ligowave NFT 2N Access Point Firmware 7.52

What’s new in 7.52 firmware release- Added UAM/CoovaChilli support (Throughput up to 60Mb/s) - Added repeater mode with third party AP support - Added router mode - Added an option to close wireless session from RADIUS (RADIUS initiated disconnect) on WPA/WPA2-Enterprise - Added option for indoor-outdoor channels-frequency filtering in list - ...

Ligowave LigoDLB Router Firmware 7.53

What’s new in 7.53 firmware release- Upgrading notes: 7.53 iPoll 3 does not connect to previous iPoll 3 firmware versions if encryption is enabled. - LigoDLB (7.53) iPoll 3 is only compatible with LigoDLB series - LigoDLB (7.52) iPoll 2 is compatible with Deliberant APC (7.02) iPoll 2 NEW:- Added operating ...

Ligowave LigoPTP MIMO/PRO/UNITY Firmware 6.95

New revision 49663 of 6.95 firmware fixes following QoS problems on the PTP-5 PRO: - QoS does not work properly when vlan is enabled on the radio - The lowest queue drops the packets when higher queues do not have trafficSpecial notes- v6.95 firmware won’t allow to downgrade lower than 6.93 ...

Ligowave LigoPTP RapidFire Firmware 7.53-2

Changes:New: - Added Idle/Active operation states, which balance between low latency and high throughput Improvements: - Improved link stability and performance in low temperature environment - Applied DFS FCC waveform tuning Fixes: - Fixed GUI issues when CT country configured with more than 31 dBm gain - Fixed TX ...

Ligowave LigoPTP MIMO/PRO/UNITY Firmware 6.95-1

Special notes- v6.95-1 firmware won’t allow to downgrade lower than 6.93 firmware version - In order to see link statistics and signal levels firmware version must match on both sides What’s new in LigoPTP MIMO/PRO/UNITY 6.95-1 FW releaseImprovements - Returned recovery-mode fix into firmware - Added a counter of radar detections ...

Ligowave LigoPTP RapidFire Firmware 7.53-3

What’s new in LigoPTP RapidFire 7.53-3 firmware service release:New: - Added SNMP traps - Added Ligowave wireless MIBs with proprietary SNMP objects Fixes: - Fixed issue when radio stops passing traffic after receiving jumbo packet - Fixed DFS working algorithm - Fixed high jitter ping issue - Fixed small packets issue ...

Ligowave LigoPTP MIMO/PRO/UNITY Firmware 6.95-2

Special notesv6.95-2 firmware won’t allow to downgrade lower than 6.93 firmware version In order to see link statistics and signal levels firmware version must match on both sides What’s new in LigoPTP UNITY 6.95-2 FW release:Improvements - Improved flash memory robustness against bad blocks  About Gateway Firmware:By applying this firmware, your ...