Ruijie Reyee RG-EW1200G PRO V3 Router Firmware EW_3.0(1)B11P219

New Features

Reyee Mesh 3.0
- Contain Wired mesh networking, AP Networking

CLS Level 1 Certification
- When accessing the device management interface, the HTTPS protocol is implemented The protection mechanism for entering incorrect passwords

OpenVPN
- OpenVPN can be used to establish a secure virtual private tunnel between different sites, or between a client and a site, allowing users to access the intranet over ISP networks. (Remark: Not for EW300-PRO).

Guest Isolation
- Enable wireless clients on the Guest Wi-Fi to access the Internet, and to prevent them from accessing the intranet and from communicating with each other.

Guest-WiFi Speed Limit
- Support to set rate limit for Guest Wi-Fi

IPTV/IGMP
- The configuration applies to FPT ISP. After it is enabled, connect the IPTV STB to any LAN port of the router.

WPA3
- WPA3 is the WI-FI Alliance's new encryption protocol for Wi-Fi, released in 2018. It is a follow-up to WPA2, the WI-FI authentication standard.

Changed Features

WiFi Password/ Login Password
- Greater than or equal to 8,less than or equal to 65

Upgrade Procedure

(1) Power on the device. Connect the PC to the LAN port of the device and set the IP address of the PC to
Obtain an IP address automatically
(2) Open a browser, enter 192.168.110.1 into the address bar of the browser and press Enter.
(3) Navigate to Network Setup to configure the network and enter homepage.
(4) Navigate to System > Upgrade > Local Upgrade. Click Browse, select an upgrade file (e.g.,
EW_3.0(1)B11P219_EW3200GXI_10182113.tar.gz ) and click Upload

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.