Panasonic WV-SC384 Network Camera Firmware 2.10.127

Changes:

- Supported displaying H.264/JPEG images on Safari (v5.1.7), Firefox (v32.0.3) and Google Chrome (v38.0.2125)
- Improved displaying live picture even if the setting of the Compatibility View on Internet Explorer11 were "Off".
- For SD memory card, added warning output, usage information and error information.
- Added "SD memory card warning output" at the "Alarm output terminal".
- Supported time and camera title can be displayed by separation.
- Changed indication order of ONVIF Profile when obtaining them;
- Reviewed and updated the Time Zone values.
- Unable to download the Alarm log. When "Not Use" is selected for SD memory card and either "H.264(1）" or "H.264(2)" (in gray) is selected for recording compression.
- By detecting interruption of a camera connection for 2 minutes and leaving message "Connection has been disconnected. Please confirm connection." more than 2 minutes, the message on another camera would be sent every 30 seconds. In a case, two or more cameras were registered and selected multiscreen.
- In second alarm, FTP alarm notification sent post-alarm images without pre-alarm JPEG images. In a case, the followings were set;
- In RTP over RTSP over HTTP, no replied to GET connection. In a case, Method of POST connection became BASE64 and divided packets.
- GET Connection was disconnected before replying RTSP Error. In a case, sending RTSP Method while disconnecting POST in RTP over RTSP over HTTP every time.
- Replied RTSP with a header of Speed. (Occurrence frequency: High) When specifying "Rate-Control: no". Fixed.
- In information range for GetRecordingOptions command, the responses of CompatibleSources was vary depends on job generation state.
- E-mail notification: No images attached
- FTP Periodic image transmission: Not sent
- 1-shot image: Solid black.
- Added unnecessary "0" at the end of POST connection of RTP over RTSP over HTTP.
- Replied "500 Internal Server Error" by specifying a time that was out of recording to play. While playing back on SD memory card.
- Fixed to replay "404 Not Found」".
- FTP periodic image transmission did not send correct intervals;
- Deleted the redundant "HTTP/1.0 200 OK" from the response.

About Network Camera Firmware Updates:

Updating to a newer firmware version than the one already installed on your network camera can improve the device's overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera's firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device's performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera's firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don't end up with a broken device. This process isn't intended to be destructive, but still, it's best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don't miss the update that will boost your camera's performance.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.