Panasonic DC-S5M2 Camera Firmware 2.2

[AF-Point Scope] Function has been added

- Added an AF point scope function that allows you to enlarge the focus position during AF.

High resolution mode function has been enhanced

- It is now possible to set the shutter speed up to 8 seconds in the High Resolution mode. In addition, [Long Exposure NR] can be used.
- Thanks to the image stabilizer, [Handheld High-Res] mode has been added to enable recording pictures with higher resolution even without using a tripod. During [Handheld High-Res] mode, the shutter speed can be set at max 1 second.

MF Assist Magnification Setting has been added

- It is now possible to magnify the full screen mode display in MF Assist up to approx. 20 times when recording pictures.

Other performance improvements

- Improved the switching speed between LCD and LVF.
- Improved viewfinder visibility between continuous shooting frames.
- Improved operational stability.

Update Procedure:

- Charge the battery fully.
- Make sure to turn off the power switch.
- Insert the fully charged battery to the body.
- Save and unzip the downloadable package.
- Transfer the content onto a formatted SD memory card and insert it into the camera body.
- Turn on the power switch.
- Press the Play button to enter the Play mode.
- After the message of "PLEASE WAIT ..." is displayed, a display will continuously be shown on the LCD.
- If newer version or same version of firmware has already been installed, the initial setup screen will not be displayed. And the lens will display that "NO VALID PICTURE TO PLAY". Please turn off your camera and use the camera as is.
- Press [(Left Cursor button)] to select the [Yes]. The update process will start.
- The camera body will start the update process.
- The firmware update will take about 5 minutes.
- Please do not attempt the following operations before completion.
- The green bar increases the level by the process.
- Once the firmware update process is completed, the camera dody will turn off the power and turn on again then it will be initial mode automatically.
- Turn off the power switch.
- Remove the SD memory card.

Important Notes:

- Do not turn the power off and on
- Do not press any buttons
- Do not open the SD memory card compartment
- Do not remove the SD memory card
- Do not remove the lens. 

About Digital Camera Updates:

Updating to a newer firmware version than the one already installed on your camera can improve the device's overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera's firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device's performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera's firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn't intended to be destructive, but still, it's best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don't use the camera's buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device's update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product's installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don't miss the update that will boost your camera's performance.