- Added the option to enable/disable 802.11w Protected Management Frames (PMF) support.
- Added ping test diagnostic tool.
- WDS enhancements (no AP reboot required while configuration)
- MAC ACL enhancements (added deny policy support).
- Factory reset is no longer required when switching from Insight mode to Standalone mode.
- Provision for AP to switch firmware from Primary to Secondary when AP is operating in Standalone mode.
- Multiple fixes for MAC ACL feature.
- Non-Management VLAN clients are not getting Internet access when URL Filtering is enabled.
- Wireless and wired clients cannot access the Internet after changing the Routers name.
- Default Captive Portal image does not load on iOS devices when AP is operating in Router mode.
- Blocked URL list is not pushed to AP after reboot.
- Various improvements on User Interface and dashboard.
- Improvement in firmware stability.
- From 3.1.0.12 release there is a change in the behavior when AP is being downgraded to a lower version firmware. The configuration will go to factory reset mode and will not be retained. It is recommended to save the configuration before upgrading the firmware so that if any scenario when there is a downgrade needed to old firmware, same can be restored after downgrade.
- Need to clear browser cache to get latest UI changes.
If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.
Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.
It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.
With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
Top 4 Download periodically updates information of NETGEAR WAC510 Access Point Firmware 3.1.0.12 full driver from the manufacturer, but some information may be slightly out-of-date.
Using warez version of NETGEAR WAC510 Access Point Firmware 3.1.0.12 driver is hazardous. Our driver download links are directly from our mirrors or publisher's website, NETGEAR WAC510 Access Point Firmware 3.1.0.12 torrent files or shared files from free file sharing and free upload services, including Rapidshare, HellShare, HotFile, FileServe, MegaUpload, YouSendIt, MailBigFile, DropSend, MediaMax, zUpload, MyOtherDrive, SendSpace, DepositFiles, Letitbit, LeapFile, DivShare or MediaFire, are not allowed!
It is not recommended to download drivers from illegal sites which distribute a keygens, key generators, pirate keys, serial numbers, warez full versions or cracks for NETGEAR WAC510 Access Point Firmware 3.1.0.12. These drivers might corrupt your computer installation or breach your privacy. A driver might contain a trojan horse opening a backdoor on your computer. Hackers can use this backdoor to take control of your computer, copy data from your computer or to use your computer to distribute viruses and spam to other people.
Download Now
Update All Drivers
