MikroTik RouterOS X86 Firmware 7.20.7

What's new in 7.20.7:

- bgp - fixed l2vpn-cisco decoding (introduced in v7.20);
- bgp - fixed occasional corruption of MPLS labels in BGP VPN update messages;
- bridge - fixed dynamic switch-cpu VLAN creation (introduced in v7.20);
- bridge - improved system stability when forwarding traffic with fast-path and bridged interface gets removed or disabled (introduced in v7.20);
- bth - make user private-key sensitive;
- console - fixed empty output in route menus when using "print where gateway";
- console - updated copyright notice;
- firewall - clear relevant masqueraded connection tracking entries on IP address change;
- ipv6 - initialize RA receiving when enabled and without any other IPv6 configuration;
- log - fixed memory leak;
- lte - fixed LTE interface IPv6 address generation to use EUI-64 (introduced in v7.20);
- lte - fixed no re-connection after cellular network requested APN deactivation on Chateau 5G ax R17;
- ovpn - fixed OVPN server handling on reboot (introduced in v7.20);
- ovpn - improved system stability when using cipher=blowfish128;
- sfp - fixed "sfp-tx-fault" state indication for CRS520-4XS-16XQ;
- sfp - fixed missing link up/down notifies;
- switch - fixed non-IP multicast packet receive on 98DX8208, 98DX8216, 98DX8212, 98DX8332, 98DX3257, 98DX4310, 98DX8525, 98DX3255, 98CX8410 switches;
- system - detect policy mismatch sooner if script is executed internally by some other service;
- ups - fixed board hibernation shutdown;
- wifi-mediatek - added Superchannel regulatory profile;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.