MikroTik RouterOS TILE Firmware 6.48.5

Changes since 6.48.4:

- branding - properly clean up old branding files before installing a new one;
- crs3xx - fixed default MAC address calculation on management Ethernet for CRS312, CRS326-24S+2Q+ and CRS354 devices;
- gps - improved interface monitoring;
- health - improved temperature reporting;
- ike2 - check if TS is still valid after obtaining SPI;
- ipsec - improved SA update by SPI;
- netinstall - require Netinstall version to be the same or newer as "factory-software";
- poe - update PoE firmware only on devices that supports it;
- ppp - improved stability when receiving bogus response on modem channel;
- qsfp - improved system stability when setting unsupported link rates;
- sfp - added "sfp-rate-select" setting (CLI only);
- sfp - improved SFP, SFP+, SFP28 and QSFP+ interface stability for CRS3xx and CCR2004 devices;
- sfp28 - changed FEC auto mode to disabled;
- w60g - limit power output when using region EU to match EN302567 on nRAY;
- w60g - use EU region by defau<
- winbox - added "name" and "file-name" parameter when importing and exporting certificates;
- winbox - allow setting MCS (24-31) to 4x4 Wireless interfaces;
- winbox - do not allow to set empty "init-string" field under "System/GPS" menu;
- winbox - do not show "GPS antenna" selection for devices without selection support;
- winbox - show "System/Health/Settings" only on boards that have configurable values;
- winbox - show "current-channel" column by default for CAP interfaces;
- wireless - added U-NII-2 support for US and Canada country profiles for hAP ac lite;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.