MikroTik RouterOS SMIPS Firmware 6.35.4

What's new in 6.35.4:

- address-list - make "dynamic=yes" as read-only option;

- bonding - fixed 802.3ad load balancing mode over tunnels ;

- bonding - fixed bonding primary slave assignment for ovpn interfaces after startup;

- bonding - fixed crash on RoMON traffic transmit;

- dhcpv6 client - fixed ia lifetime validation when it is set by dhcpv6 client;

- disk - added support for Plextor PX-G128M6e(A) SSD on CCR1072;

- ethernet - fixed memory leak when setting interface without changing configuration;

- firewall - do not show disabled=no in export;

- health - fixed broken factory voltage calibration data for some hAP ac boards;

- health - fixed incorrect voltage after reboot on RB2011UAS;

- ipsec - fixed mode-config export;

- ipsec - fixed route cache overflow when using ipsec with route cache disabled;

- lte - use only creg result codes as network status indications;

- ovpn - enable perfect forwarding secrecy support by defau<

- rb3011 - fixed port flapping on ether6-ether10;

- rb3011 - fixed reset button functionality;

- rb3011 - improved performance on high cpu usage;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer