MikroTik RouterOS SMIPS Firmware 6.34.5

What's new in 6.34.5:

- dude - in order to connect to dude server user requires dude policy to be enabled;

- bonding - do not corrupt bonding statistics on configuration changes;

- bonding - fixed crash when vlan parent mtu is higher than bonding mtu;

- cloud - do not write minor status changes to storage;

- ethernet - do not allow mtu to be higher than l2mtu and l2mtu to be higher than max-l2mtu (reduce automatically on upgrade if it was wrong before);

- ipsec - better flush on proposal change;

- ipsec - fixed crash on policy update;

- log - fixed reboot log messages;

- lte - do not allow to set multiple modes when it is not supported;

- queue - fixed interface queue type for ovpn tunnels;

- rb3011 - fixed port flapping on ether6-ether10;

- rb3011 - fixed time keeping;

- switch - fixed compact export;

- tile - fixed performance regression on switch chip (introduced in 6.33rc18);

- winbox - show voltage in Health only if there actually is voltage monitor;

- wireless - fixed issue when CAPsMAN could lock CAPs interface;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device. 

It is highly recommended to always use the most recent driver version available

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games

Try to set a system restore point before installing a device driver

This will help if you installed a wrong driver

Problems can arise when your hardware device is too old or not supported any longer