MikroTik RouterOS PPC Firmware 6.34.4

What's new in 6.34.4:

- bonding - fixed crash on bonding slave release;
- bonding - fixed mac-address disappearance after reboot in specific setups;
- chr - fixed reboots with license and queues;
- console - allow unknown scan-list names on wireless configuration to fix import;
- fastpath - fixed rare kernel failure;
- ipsec - take into account ip protocol in kernel policy matcher;
- mac-winbox - try to aggregate packets & resend all pending packets on timeout;
- ppp - do not crash when received multiple CBCP packets;
- ppp - fixed crash when ppp interface gets disconnected and user gets authenticated at the same time (most probable with slow RADIUS server);
- quickset - fixed wan interface selection on devices with SFP interfaces;
- quickset - use 5GHz interface instead of 2GHz interface on SXT Lite5 ac;
- rb3011 - fixed high cpu load breaks ethernet stats;
- rb3011 - fixed link down messages;
- romon - fixed romon discovery after romon ID change;
- timezone - fixed reboot by watchdog when selecting timezones from the end of list;
- userman - fixed www crash;
- winbox - allow to show revoked & authority flags at the same time;
- winbox - correctly recognise if there is need to report fan information under system health;
- winbox - do not use area v2 names instead of ospf v3 area names;
- winbox - make mac-winbox work with RB850.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.