MikroTik RouterOS MIPSBE Firmware 7.3 Beta 37

What's new in 7.3beta37:

- bonding - fixed LACP flapping for RB5009 and CCR2004-16G-2S+ devices;
- bridge - fixed packet marking for IP/IPv6 firewall;
- dot1x - improved server stability when using re-authentication;
- fetch - improved full disk detection;
- gps - fixed minor value unit typo;
- l3hw - improved offloading for directly connected hosts on CRS305, CRS326-24G-2S+, CRS328, CRS318, CRS310;
- led - fixed QSFP+, QSFP28 activity LEDs when using 40Gbps modules (introduced in v7.3beta33);
- lte - disabled wait for LTE auto attach;
- mpls - fixed MPLS MTU and path MTU selection;
- ovpn - fixed hardware offloading support on CHR;
- ovpn - improved Windows client disconnect procedure in UDP mode;
- ovpn - moved authentication failure messages to "info" logging level;
- ppp - added warning when using prefix length other than /64 for router advertisement;
- ppp - fixed "remote-ipv6-prefix" parameter unsetting;
- ppp - fixed issue with multiple active sessions when "only-one" is enabled;
- routerboot - properly reset system configuration when protected bootloader is enabled and reset button used;
- rsvp-te - improved stability when "Resv" received for non-existing session;
- sfp - improved QSFP/SFP interface initialization for 98DXxxxx switches;
- switch - fixed missing stats from traffic-monitor for 98DXxxxx and 98PX1012 switches;
- system - fixed RouterOS bootup when wifiwave2 package is installed (introduced in v7.3beta34);
- system - fixed rare partial loss of RouterOS configuration after package upgrade/downgrade/install/uninstall;
- user-manager - improved stability when received EAP attribute with non-existing state attribute;
- vpls - fixed "pw-l2mtu" parameter usage;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.