Intel RMS3HC080 RAID Module Firmware 24.21.0-0132

Firmware Package: 24.21.0-0132 (iMR 6.14 Point Release 6)

- Firmware 4.680.01-8526
- ROMENV 1.10
- BootBlock 3.07.00.00-0004
- NVDATA 3.1705.01-0013
- UEFI_Driver 0x06180203 (SIGNED)
- Hii 03.25.05.13 (SIGNED)
- FCODE 4.19.08.00
- BIOS 6.36.00.3
- Ctrl-R 5.19-0603
- PCLI 1.07.05

Bug Fixes and Enhancements:

- DCSG00230289 (Closed): MR FW 6.14 - Integration of 3108 Phase 14 MR PL FW Version - 14.00.15.00
- DCSG00146867 (Closed): MR FW 6.14 - Integration of 3108 Phase 14 MR PL Version - 14.00.14.00
- DCSG00134675 (Closed): MR6.14: Crytoerase Sanitize Type is failing on SED Drive
- DCSG00072635 (Resolved): storcli return with error when set patrolread mode
- DCSG00068474 (Closed): Creating VD for Direct Connect fails
- DCSG00102246 (Resolved): Dev defect to investigate CLCA code review finding for DCSG00051973 - possible loss of snap dump during abrupt power loss
- DCSG00074489 (Resolved): SEP discovery issue after reset / enclosure reset - RMDP-528
- DCSG00146729 (Resolved): Dev defect MR 6.14: Address code review defect D40667 for disabling L3
- DCSG00129646 (Closed): MR6.14: Drive state change to Sanitize after crypto erase operation completion "storcli64.exe /c0/e42/s20 start erase crypto"
- DCSG00129198 (Closed): MR6.14:WG: Sanitize operation does not show remaining time in progress bar notification/Event logs
- DCSG00146728 (Resolved): MR 6.14:While clearing the configuration sanitize running drives state has been changed from “SANITIZE_IN_PROGRESS(4) to UNCONFIGURED_GOOD(0)”.

About SATA / AHCI / RAID Controller Drivers:

When enabled by appropriate software, the SATA controller (RAID or AHCI) is properly recognized by the system and all of its features are made accessible.

In addition to that, the computer will have the ability to read all adapter characteristics, such as model and manufacturer, and will also be able to manage physical disk drives through the controller's interface.

If you wish to apply this package, all you have to do is to make sure that the current release is compatible with both your adapter model and your operating system, and then to get the downloadable software. Extract it if necessary, run the available setup, and follow the on-screen instructions for a complete installation.

When finished, remember to perform a system reboot to make sure that all changes take effect properly. Please remember that, even though other OSes might also be compatible, we do not recommend installing this software on platforms other than the specified ones.

That being said, click the download button, get the package and apply it on your computer. Moreover, constantly check with our website to stay up to date with latest releases.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.