Atomos Shogun Studio 2 Controller Firmware 3.5

How to update:

- Download the latest version of AtomOS for Shogun Studio 2 and the Controller Update from atomos.com/support.
- Disconnect the power cable from the Shogun Studio 2.
- Unzip ATOMSGNST_x.x.zip and place the file ATOMSGNST.bin onto a USB flash drive. Connect the flash drive to the USB port of the back of the unit.
- NOTE: The USB flash drive must be formatted as FAT32.
- Connect the power cable to the Shogun Studio 2.
- Near the USB port, a blue LED will begin flashing. It will take a few minutes for the Controller Update to complete. The unit will automatically start up once the update is complete.
- Confirm the update installed correctly by opening the unit Info page where it will display the Controller version number.
- Power off the Shogun Studio 2 and remove the USB flash drive.
- Unzip ATOMST2_X.X.zip and copy ATOMST2.FW onto an SSD.
- Place the SSD into the first unit and power up.
- NOTE: Both units can be updated at once by copying ATOMST2.FW onto two SDDs and placing them into both caddies before powering up.
- AtomOS will begin updating.
- Remove the SSD before the update is complete and the update file will still be on the SSD.
- Once AtomOS has been updated on unit 1, power down.
- Place the SSD into unit 2 and power up and AtomOS will install.
- Once the update is complete, go the Info page on each unit. The latest version will be displayed on both displays if installed correctly.

About Video Recorder Adapter Updates:

Applying a new firmware package on your Video Recorder adapter should improve overall performance and stability, fix various issues encountered with the device, or add support for newly developed features.

The Video Recorder adapter should be carefully upgraded by a power user (that is to say, someone who has the know-how to successfully complete the process), but it can also be performed by an average user at his or her own risk.

Either way, given the fact that each producer has their own method for installing a new firmware, and that every device has a particular way to enter the update mode, you must not consider upgrading the adapter's software until you have read and thoroughly understood the installation steps.

As a rule, said steps shouldn't pose too much of a challenge because manufacturers strive to make them as easy as possible. As with everything else, exceptions do occur, and users should be prepared for them.

Usually, you should transfer the compatible firmware to the Recorder through a USB cable or a memory card, and afterwards enter update mode from the unit's setup menu or through a specific power-on method.

With this in mind, if you intend to apply this release, make sure the package is compatible with your Video Recorder and that it brings about the changes you want or require; hit the download button and apply the new firmware.

Don't forget to regularly check with our website so that you don't miss any updates.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.